Sale!

EMP Bags 4 Sizes, 5 each

From $82.50 $75.00

The Dri-Shield 3400 series bags were shown to be superior to all others, providing approximately 50 dB of shielding across all relevant EMP frequencies (100 kHz to 1 GHz). That means they will reduce the electric field by at least 99.7%, reducing even a worst-case 50,000 V/m down to 158 V/m – a level that most electronics would survive.

Description

One of the easiest ways to protect electronic equipment from the damaging effects of an EMP is to store them in RF-shielded bags. The challenge becomes picking out bags that provide the highest level of shielding. Most bags sold on the internet have never even been tested for shielding effectiveness. Don’t be fooled by people testing with stun guns – that’s just for show and completely irrelevant to EMP protection.

With a PhD in electrical engineering, I was fortunate enough to have the equipment to test numerous brands of bags for their shielding effectiveness. The Dri-Shield 3400 series bags were shown to be superior to all others, providing approximately 50 dB of shielding across all relevant EMP frequencies (100 kHz to 1 GHz). That means they will reduce the electric field by at least 99.7%, reducing even a worst-case 50,000 V/m down to 158 V/m – a level that most electronics would survive.

Please see the FAQs section to learn more about layering and sealing the bags.

If you’d like to see more about how I conducted the tests, check out my videos on youtube. One of them in which I discuss EMP bags is given below:

Reviews

There are no reviews yet.

Be the first to review “EMP Bags 4 Sizes, 5 each”

Your email address will not be published. Required fields are marked *

A few questions that I am often asked:

1. Is one layer really enough? The short answer is YES. A good EMP bag can reduce the fields by 99.7% or more. That’s enough for protect nearly any electronic item. This may not be true with other bags, so if they’re suggesting multiple layers, the company is either uncertain of their product, trying to dupe you into buying more than you need, or have a product that is not quite up to these standards.

2. How do I seal up the bags? If you’re wanting to get in and out of the bag, just fold the lip over twice and tape with any standard tape. There’s no need for conductive tape; Scotch tape will do fine. An alternative is to clip them closed with clothespins or other clips. If you want to permanently seal the bag, you can use a hot iron to melt the top closed.

3. Do you make these bags? No. I re-sell them for another company. They in turn buy them direct from the manufacturer. Anyone can buy them, so you can certainly go out and set up a retailer account and buy them yourself. You’ll save a few dollars, but honestly, not much. Much of the cost is in the shipping.

4. Why are you re-selling them? I received so many requests to recommend bags, and then when I did, folks couldn’t figure out where to buy them in small quantities. I finally decided to be the middle man and help people order high-quality EMP bags.

5. Can I trust that these are the best bags out there? They’re the best bags I’ve tested, and I’ve tested quite a few. What’s more important is that have been shown to be effective for the frequencies of an EMP. Many other companies (no names mentioned) sell their bags using hype and misleading tests.